YE-5 KIT, Pump Configuration: 5 Outputs (2 speed uses 2 outputs), BLO: Y, CIRC: Noted, OZONE: Y, Heater: 5.5kW, Light: 12V, Topside: BDLK2002OP.

**IN.YE-5 Control System Bundle with choice of topside control keypad.** - **4 kW or 5.5 kW Heater** - Can be wired to 220V or 110V. If the main power is 220V, then all components can be configured for 110V or 220V. - Includes Cord Kit for Pumps & Light (see below for details). - Features a solid-state flow detection system, which eliminates the pressure switch found in traditional spa packs. - Preloaded configuration settings allow for fast and easy programming. - Compatible with the Gecko WiFi module. - Dimensions of control system: 19.6" x 10.75" x 2.87", heater is 15" wide with standard 2" connections **The YE-5 has 5 configurable relays & this will determine the amount of equipment you can run. Each 2-speed pump will use 2 relays**, while other 1-speed pumps, blowers and ozonators will use 1 relay each. A stereo or television can also be powered and will not use one of the relays. You have the option of running up to (2) 2-speed pumps. Most hot tubs will have at least (1) 2-speed pump, and low speed is used to heat and filter your hot tub. If your tub has a **\*\*circulation pump (see disclaimer at bottom of page)** for heating & filtering, you have the option to configure all pumps as 1-speed. **Choose between 4 Topside Controls (keypads):** **in.k200 topside keypad** - 4-3/4" X 2" (includes adapter plate if you need to cover a larger hole) **i****n.k300 topside keypad** - 6-1/4" x 2-1/4" (includes adapter plate if you need to cover a larger hole) **i****n.k450 topside keypad** - 7-1/8" x 2-7/8" (includes adapter plate if you need to cover a larger hole) **i****n.k8-3OP topside keypad** - 7" x 3-1/4" (includes adapter plate if you need to cover a larger hole) **Includes Cord Kit:** **4 wire cords** **(2 included)**: 2-speed pumps require a 4-wire cord. **3 wire cords** **(2 included****)**: 1-speed pumps, blowers, ozonators, audio, video use a 3 wire cord. Cords are Amp 4-Prong style that connect directly to the circuit board. **Includes Light Cable**. A unique Gecko power cord that plugs into the board for a regular 12V spa light or LED light. **\*\*Use of circulation pump on the Y-Series:** Most spas don't have a small circulation pump, instead, the main pump runs on low speed to heat and filter the water during set filtration cycles. If you are using a small circulation pump, the flow rate must be at least 20 gallons per minute. In other words, the circulation pump must be similar to a Waterway Iron Might or Aquaflo Circmaster Pump and require a minimum 1.5" size plumbing. **Pumps like the Waterway Tiny Might or Laing E10 Circulation Pump are too small and will not work with this control system.** **If you have a circulation pump, we recommend the 4 kW model because the programming is much easier.**Gecko doesn't advise using 5.5 kW with circulation pumps, so standard programming can't be used and the initial programming is much more complicated.